Shield Autocare Windows Fitting Instructions -

| Problem | Likely Cause | Solution | | :--- | :--- | :--- | | | Gap between shield and door frame | Apply a small piece of clear 3M tape to the leading edge (near mirror). Or, gently heat the shield with a hair dryer and bend it inward. | | Window auto-reverse (bounces down) | In-channel shield too thick | Shim the shield with a plastic trim tool to reduce pressure. Alternatively, trim 1mm of rubber from the window channel using a utility knife (warranty voiding – last resort). | | Adhesive lifting at corners | Surface was cold or oily | Remove the shield (see below). Re-clean with acetone (carefully) and reapply using 3M Super Strength Adhesive. | | Shield rattles over bumps | Loose in the channel | Apply 3M double-sided foam tape to the underside of the shield’s clip. Do not use silicone caulk. |

Use masking tape to mark the position of the glass on the shield autocare windows fitting instructions

Lower your windows halfway to access the top of the glass and the inner rubber channels. | Problem | Likely Cause | Solution |